CAB−530MT Serial Cable Specifications
Document ID: 46802
Introduction
Prerequisites
Requirements
Components Used
Conventions
CAB−530MT Serial Cable Assembly
EIA−530 DTE Cable Pinouts (DB−60 to DB−25)
Related Information
Introduction
This document provides the technical and cable specifications for the CAB−530MT serial cable.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
CAB−530MT Serial Cable Assembly
The cable gender for this product (part number 72−0797−01) is Male DB−60 to Male DB−25, mode − DTE
only.
The CAB−530MT cable is used in the Cisco 7000 family, Cisco 4000 series, Cisco 3600 series, Cisco 2500
series, Cisco 1600 series, Cisco access servers, and AccessPro PC cards. This cable has a male DB−60
connector on the Cisco end and a male DB−25 connector on the network end.
To Next Page
Need help?
General