Cisco Catalyst 4500 Series - Page 1217

Index
IN-9
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
In Service Software Upgrade
See ISSU
inspection log
clearing log buffer 2-105
interface
displaying suppressed multicast bytes 2-712, 2-714
interface (virtual switch) command 2-287
interface capabilities
displaying 2-710
interface configuration mode
summary 1-5
interface link
display cable disconnect time 2-718
interfaces
configuring dot1q tunnel ports 2-1049
creating an interface-range macro 2-183
debugging output of interface related activities 2-142
displaying description 2-717
displaying error-disabled state 2-721
displaying information when tunneling is
enabled
2-806
displaying status 2-717
displaying traffic for a specific interface 2-707
entering interface configuration mode 2-285, 2-287
executing a command on multiple ports in a
range
2-290
selecting an interface to configure 2-285, 2-287
setting a CoS value for Layer 2 packets 2-392
setting drop threshold for Layer 2 packets 2-393
setting the interface type 2-1049
interface speed
configuring interface speed 2-1017
interface transceiver
displaying diagnostic data 2-725
internal VLAN allocation
configuring 2-1122
default setting 2-1122
displaying allocation information 2-956
Internet Group Management Protocol
See IGMP
IP address of remote ANCP server, setting 2-17
IP ARP
applying ARP ACL to VLAN 2-294
clearing inspection statistics 2-106
clearing status of log buffer 2-105
controlling packet logging 2-305
enabling dynamic inspection 2-303
limit rate of incoming requests 2-296
set per-port config trust state 2-300
showing status of dynamic ARP inspection 2-732
showing status of log buffer 2-735
IPC
debugging IPC activities 2-153
IP DHCP Snooping
See DHCP snooping
IP header validation
disabling 2-351
enabling 2-351
IP interfaces
displaying usability status 2-757
IP multicast
displaying multicast routing table information 2-763
ip multicast multipath command 2-344
IP packets
enable DSCP rewrite 2-579
IP phone and standard desktop
enabling Cisco-recommended features 2-426
IP Port Security
enabling 2-352
IP source binding
adding or deleting 2-348
displaying bindingstagging 2-768
IP source guard
debugging messages 2-156
displaying configuration and filters 2-769
enabling on DHCP snooping 2-352
IPv4 statistics, enabling collection 2-136
IPv6 MLD