Cisco Catalyst 4500 Series - Page 1220

Index
IN-12
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
system-cpp 2-449
mapping secondary VLANs to MST instance 2-572
mapping VLAN(s) to an MST instance 2-282
match (class-map configuration) command 2-14, 2-188,
2-190, 2-192, 2-194, 2-454, 2-575, 2-1024, 2-1026, 2-1028, 2-1030,
2-1034
maximum transmission unit (MTU)
displaying the system MTU setting 2-942
setting the maximum Layer 2 payload size 2-1076
MD5
verifying MD5 signature 2-1106
message digest 5
See MD5
MFIB
clearing ip mfib counters 2-114
clearing ip mfib fastdrop 2-115
displaying all active MFIB routes 2-760
displaying MFIB fastdrop table entries 2-762
enabling IP MFIB fastdrops 2-343
MLD
configuring snooping
last-listener-query-intervals
2-371
configuring snooping
listener-message-suppression
2-373
configuring snooping robustness-variables 2-374
configuring topology change notifications 2-376
counting snooping last-listener-queries 2-369
enabling snooping 2-367
enabling snooping on a VLAN 2-377
MLD snooping
displaying 2-785
modes
access-group 2-6
show access-group interface 2-553, 2-639, 2-902
switching between PVST+, MST, and Rapid
PVST
2-994
See also command modes
module password clearing 2-101
module reset
resetting a module by toggling the power 2-274
monitor capture {access-list | class-map} command 2-466
monitor capture mycap match command 2-473
monitor capture start command 2-475
--More-- prompt
filter 1-6
search 1-7
MST
designating the primary and secondary root 2-1003
displaying MST protocol information 2-931
displaying region configuration information 2-931
displaying spanning tree information 2-931
entering MST configuration submode 2-997
setting configuration revision number 2-608
setting path cost and port priority for instances 2-995
setting the forward delay timer for all instances 2-999
setting the hello-time delay timer for all
instances
2-1000
setting the max-age timer for all instances 2-1001
setting the MST region name 2-486
specifying the maximum number of hops 2-1002
switching between PVST+ and Rapid PVST 2-994
using the MST configuration submode revision
command
2-608
using the submode name command 2-486
MTU
displaying global MTU settings 2-942
multi-auth, setting 2-30
Multicase Listener Discovery
See MLD
multicast
enabling storm control 2-1022
show ancp 2-642
multicast/unicast packets
prevent forwarding 2-1048
Multicast Forwarding Information Base
See MFIB
multi-domain, setting 2-30
multiple-character patterns 1-8
Multiple Spanning Tree