Cisco Catalyst 4500 Series - Page 1222

Index
IN-14
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
configure on an interface 2-541
PoE policing and monitoring
displaying status 2-899
police (percent) command 2-515
police (two rates) command 2-517, 2-519
police command 2-510
policing, configure PoE 2-541
policing and monitoring status
displaying PoE 2-899
Policy Based Routing
See PBR
policy maps
creating 2-523
marking 2-620
See also QoS, hierarchical policies
traffic classification
defining the class
defining trust states 2-1092
port, dual-capable
selecting the connector 2-463
Port Aggregation Protocol
See PAgP
port-based authentication
displaying debug messages 2-149
displaying statistics and status 2-679
enabling 802.1X 2-225
host modes 2-218
manual control of authorization state 2-225
periodic re-authentication
enabling 2-228
re-authenticating 802.1X-enabled ports 2-227
switch-to-client frame-retransmission number 2-223
port channel
accessing 2-289
creating 2-289
displaying information 2-872, 2-874
load distribution method
resetting to defaults 2-525
setting 2-525
port-channel standalone-disable command 2-527
port control, changing from unidirectional or
bidirectional
2-23
port-control value, configuring 2-36
port range
executing 2-290
port security
debugging ports security 2-165
deleting secure or specific addresses 2-125
displaying settings for an interface or switch 2-885
enabling 2-1054
filter source IP and MAC addresses 2-352
setting action upon security violation 2-1054
setting the rate limit for bad packets 2-1054
sticky port 2-1054
Port Trust Device
displaying 2-905
power efficient-ethernet auto command 2-533
power inline four-pair forced command 2-538
power inline logging global command 2-540
power negotiation through LLDP, enabling 2-401
power status
displaying inline power 2-891
displaying power status 2-891
power supply
configuring combined and redundant power on the
Catalyst 4507R
2-528
configuring inline power 2-534
configuring power consumption 2-528
displaying the SEEPROM 2-701
setting inline power state 2-532
PPPoE Discovery
enable vendor-tag stripping on packetsPPPoE Server
enable vendor-tag stripping on Discovery
packets
2-562
PPPoE Discovery packets, limit rate arriving on an
interfsce
2-560
PPPoE Intermediate Agent
clear statistics (packet counters) 2-127
debugging 2-166