Cisco Catalyst 4500 Series - Page 2060

Index
IN-20
Software Configuration Guide—Release IOS XE 3.9.0E and IOS 15.2(5)E
configuring 5
overview 3
Layer 3 interface counters,configuring 11
Layer 3 interface counters,understanding 3
Layer 3 interface, applying IPv6 ACLs 20
Layer 3 interfaces
changing from Layer 2 mode
15
configuration guidelines 5
configuring VLANs as interfaces 8
overview 1
counters 3
logical 2
physical 2
SVI autostate exclude 3
Layer 3 packets
classification methods
2
Layer 4 port operations
configuration guidelines
12
restrictions 11
Leave timer, enabling 9
licenses, managing with PRTU 14
limitations on using a TwinGig Convertor 13
Link Aggregation Control Protocol, introduction 7
link and trunk status events
configuring interface
46
link integrity, verifying with REP 4
Link Layer Discovery Protocol
See CDP
link monitoring, Ethernet OAM
34, 38
link status, displaying UDLD 9
link-state tracking
configuration guidelines
26
default configuration 26
described 23
displaying status 27
generic configuration procedure 26
listening state (STP)
RSTP comparisons (table)
24
LLDP
configuring
4
characteristics 5
default configuration 5
disabling and enabling
globally
6
on an interface 7
monitoring and maintaining 14
overview 1
transmission timer and holdtime, setting 5
LLDP Media Endpoint Discovery
See LLDP-MED
LLDP-MED
configuring
procedures
4
TLVs 9, 11
monitoring and maintaining 14
overview 1
supported TLVs 2
load balancing
configuring for CEF
7
configuring for EtherChannel 18
overview 6
per-destination 7
load splitting IP multicast traffic 22
Location Service
overview
1
location service
configuring
12
understanding 3
location TLV 3, 9
logging, EPM 127
Logical Layer 3 interfaces
configuring
6
logical layer 3 VLAN interfaces 2
login authentication
with RADIUS
105
with TACACS+ 19
login banners 24
login timer