Cisco Catalyst 4500 Series - Page 1602

Index
IN-36
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL-23818-01
accessing the redundant 9-14, 10-14
configuring 3-8 to 3-13
copying files to standby 9-14, 10-14
default configuration 3-1
default gateways 3-11
environmental monitoring 12-1
redundancy 11-1
ROM monitor 3-26
startup configuration 3-25
static routes 3-11
synchronizing configurations 9-11, 10-10
Supervisor Engine II-TS
insufficient inline power handling
12-19, 13-12
Smartports macros
See also Auto Smartports macros
SVI Autostate Exclude
understanding
32-3
SVI Autostate exclude
configuring
32-7
S-VLAN 1-2, 27-7
switch 52-2
switch access with RADIUS, controlling 44-92
switched packets
and ACLs
51-25
Switched Port Analyzer
See SPAN
switchport
show interfaces
7-27, 7-28, 7-37
switchport access vlan command 17-5, 17-7
switchport block multicast command 53-2
switchport block unicast command 53-2
switchport mode access command 17-7
switchport mode dot1q-tunnel command 27-6
switchport mode dynamic command 17-5
switchport mode trunk command 17-5
switch ports
See access ports
switchport trunk allowed vlan command
17-5
switchport trunk native vlan command 17-5
switchport trunk pruning vlan command 17-6
switch-to-RADIUS server communication
configuring
44-32
sysret command 71-5
system
reviewing configuration
3-10
settings at startup 3-27
system alarms
overview
12-5
system and network statistics, displaying 35-23
system capabilities TLV 29-2
system clock
configuring
daylight saving time
4-13
manually 4-11
summer time 4-13
time zones 4-12
displaying the time and date 4-12
overview 4-2
See also NTP
system description TLV
29-2
system images
loading from Flash memory
3-30
modifying boot field 3-27
specifying 3-30
system message logging
default configuration
58-3
defining error message severity levels 58-8
disabling 58-4
displaying the configuration 58-12
enabling 58-4
facility keywords, described 58-12
level keywords, described 58-9
limiting messages 58-9
message format 58-2
overview 58-1
sequence numbers, enabling and disabling 58-7
setting the display destination device 58-5
synchronizing log messages 58-6