Cisco Catalyst 4500 Series - Page 1806

Index
IN-36
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL_28731-01
CPU port sniffing 56-10
encapsulation configuration 56-12
ingress packets 56-12
packet type filtering 56-14
spanning-tree backbonefast command 24-16
spanning-tree cost command 21-15
spanning-tree guard root command 24-2
spanning-tree portfast bpdu-guard command 24-8
spanning-tree portfast command 24-7
spanning-tree port-priority command 21-13
spanning-tree uplinkfast command 24-12
spanning-tree vlan
command
21-9
command example 21-9
spanning-tree vlan command 21-8
spanning-tree vlan cost command 21-16
spanning-tree vlan forward-time command 21-19
spanning-tree vlan hello-time command 21-18
spanning-tree vlan max-age command 21-18
spanning-tree vlan port-priority command 21-13
spanning-tree vlan priority command 21-17
spanning-tree vlan root primary command 21-10
spanning-tree vlan root secondary command 21-12
speed
configuring interface
8-20
speed command 8-21
SSO
configuring
12-10
SSO operation 12-4
SST
description
21-22
interoperability 21-24
static ACL, removing the requirement 52-28
static addresses
See addresses
static routes
configuring
3-11
verifying 3-12
statistics
802.1X
47-14
displaying 802.1X 45-125
displaying PIM 36-27
LLDP 30-14
LLDP-MED 30-14
MKA 44-4
SNMP input and output 61-16
sticky learning
configuration file
48-6
defined 48-5
disabling 48-6
enabling 48-5
saving addresses 48-6
sticky MAC addresses
configuring
48-7
defined 48-4
storing captured packets to a .pcap file, Wireshark 57-8
Storm Control
displaying
55-6
enabling Broadcast 55-3
enabling Multicast 55-4
hardware-based, implementing 55-2
overview 55-1
software-based, implementing 55-2
STP
and REP
23-6
bridge ID 21-2
configuring 21-7 to 21-20
creating topology 21-5
defaults 21-7
disabling 21-20
enabling 21-8
enabling extended system ID 21-9
enabling Per-VLAN Rapid Spanning Tree 21-20
EtherChannel guard
disabling
24-6
forward-delay time 21-19
hello time 21-17
Layer 2 protocol tunneling 28-13