Cisco Catalyst 6500 Series - Page 11

xi
Catalyst 6500 Series Content Switching Module Configuration Note
OL-4612-01
Preface
This preface describes who should read the Catalyst 6500 Series Content Switching Module Installation
and Configuration Note, how it is organized, and its document conventions.
Note Except where specifically differentiated, the term “Catalyst 6500 series switches” includes both Catalyst
6500 series and Catalyst 6000 series switches.
This publication does not contain the instructions to install the Catalyst 6500 series switch chassis. For
information on installing the switch chassis, refer to the Catalyst 6500 Series Switch Installation Guide.
Note For translations of the warnings in this publication, see the “Safety Overview” section on page xiv.
Audience
Only trained and qualified service personnel (as defined in IEC 60950 and AS/NZS3260) should install,
replace, or service the equipment described in this publication.
Organization
This publication is organized as follows:
Chapter Title Description
Chapter 1 Product Overview Presents an overview of the Catalyst 6500 series Content
Switching Module (CSM).
Chapter 2 Networking with the Content Switching Module Describes how the CSM operates on a network.
Chapter 3 Getting Started Provides quick start guide to content switching on the
CSM.
Chapter 4 Configuring VLANs Describes how to set up client and server VLANs for the
CSM.
Chapter 5 Configuring Real Servers and Server Farms Describes how to configure load balancing on the CSM.
Chapter 6 Configuring Virtual Servers, Maps, and Policies Describes how to configure health monitoring on the CSM.