Cisco Catalyst IW6300 Heavy Duty Series - Antennas Tested and Certified to UL 50 E

Antenna
Mode
Configuration
InstallationLightning
Arrestors and/or
Adapters
Coaxial CablesAntennasUse Case
Single band
Connect the 2.4 GHz
panel to ports A and B,
connect the 5 GHz panel
to ports C and D. Use
lightning arrestors if
required.
4x N(m)-N(f)
Lightning Arrestor
CGR-LA-NM-NF
and 4x N(f)-N(f)
adapter
AIR-ACC370-NF-NF
4x N(m) – N(m) cables:
CAB-L400-5-N-N
CAB-L400-5-N-NS
CAB-L400-20-N-N
CAB-L600-30-N-N
or
AIR-CAB025HZ-N
1x 2.4 GHz 13 dBi
Directional Antenna
AIR-ANT2413P2M-N=
and 1x 5 GHz 13 dBi
Directional Antenna
AIR-ANT5114P2M-N=
Directional
coverage and/or
backhaul with
both radios; each
radio covering a
different direction
Antennas Tested and Certified to UL 50E
The following antennas and IW-6300H were tested and certified to UL 50E, type 4 or 4X.
Table 4: Antennas Tested and Certified to UL 50E, Type 4 or 4X
DescriptionProduct Number
4.9 GHz-5.8 GHz 8dBi Omni with N Connector by
Laird Technologies
AIR-ANT5180V-N (Cisco PN 07-1062-01)
2.4 GHz 5 dBi Omni with N Connector by Pulse
Electronics
AIR-ANT2450V-N-HZ (Cisco PN 07-1133-01)
2.4 GHz 8dBi Omnidirectional with fixed Type N
Male Connector, by Laird Corporation
AIR-ANT2480V-N (Cisco PN 07-1058-01)
2.4-2.483. 5.25-5.85GHz 4/7 dBi Omni by Laird
Technologies
AIR-ANT2547V-N-HZ (Cisco PN 07-1134-01)
5 GhZ Directional (Panel) Antenna by Pctel IncAIR-ANT5114P2M-N (Cisco PN 07-1192-01)
2.4 GHz Directional (Panel) Antenna by Pctel IncAIR-ANT2413P2M-N (Cisco PN 07-1193-01)
PDM24519-CS2 (Panel) Antenna by LairdAIR-ANT2588P3M-N (Cisco PN 07-1194-01)
2.4 GHz/5GHz 13dBi (Panel) Antenna by Laird
Technologies
AIR-ANT2513P4M-N (Cisco PN 07-1284-01)
In addition, the following guidelines apply for UL 50E compliance:
• Type 4X indoor and outdoor compliant when used with Cisco cabling and antennas noted above.
• Type 4X indoor and type 4 outdoor compliant with Cisco provided antennas noted above and installer
provided type 4/UV compliant cable.
• When providing a non-Cisco type 4/UV compliant cable to be used outdoors, the connectors must be
either copper/aluminum, stainless or bronze/brass with at last 80% copper.
Installing the Access Point
18
Installing the Access Point
Antennas Tested and Certified to UL 50E