4030765 Rev 01 17
Logging In to the Residential Gateway
The default configuration of the residential gateway uses IP address 192.168.1.254. If
you have connected the residential gateway correctly and you have properly
configured your computer, use the following steps to log in to the residential
gateway as an administrator.
Note: A non-administrative user may need a different user name and password for
logging in to the residential gateway. These users can access non-privileged
information.
1 On your PC, open the web browser that you prefer to use.
2 In the address field, enter the following IP address: 192.168.1.254. The system
prompts you to enter your user name and password.
3 Enter admin for both the user name and password. The residential gateway
opens with the System Summary page in the forefront. You an use this web
interface to check the status of the residential gateway and to configure
parameters.
Note: The screens shown in this guide represent the default values for the
device.
To Next Page
Loading...
Need help?
General