1. Click the Edit Mode icon on the upper right part of the FM-
QUADRO view (below).
Alternatively, enter Edit mode by clicking the Settings icon on the
upper right part of the FM-QUADRO view, and clicking the Edit
Mode switch in the Appearance / Background dialog from Off to
On.
• The Edit mode dialog will be shown.
2. Click the Continue to Edit Mode button to enable Edit Mode.
• A red Edit Mode: ON notification will appear in the view.
• The Devices / Background switch control will appear in the
view (below).
3. Click the switch to the Background position.
4. Click-and-drag the Transparency slider to the position that gives a
comfortable level of visual contrast between the network
representation and the uploaded map view.
5. When the visual contrast is correct, click the Save or discard
icon (below).
• The Save new layout dialog will be shown.
6. To save your changes, click the Save changes button.
Alternatively, click the Keep editing button to return to Edit Mode,
or click the Discard button to leave Edit Mode without saving any
changes.
Exporting a network representation file
You can export a representation file of the current network layout. This
allows Fluidmesh Technical Support to visualize the network for
troubleshooting purposes.
To export a representation of the current network, do the steps that follow:
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 66 of 132
To Next Page
Loading...
