• Deactivate uploaded software plug-ins so they can be used on
other Fluidmesh units.
• Activate a non-repeatable Demo mode that allows full 4.9 GHz,
AES and unlimited plug-in functionality for an 8-hour trial period.
NOTE
4.9 GHz functionality is not available for the Cisco FM
Ponte kit.
• Show and erase the log files for plug-in installation.
To open the MANAGE PLUG-INS dialog, do the following steps:
• Click the -manage plug-ins link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• The MANAGE PLUG-INS dialog will be shown (Figure 41
(page 91)).
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 90 of 132
To Next Page
Loading...
