Index
IN-29
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
MVR
and address aliasing 21-19
and IGMPv3 21-19
configuration guidelines 21-18
configuring interfaces 21-20
default configuration 21-18
described 21-15
example application 21-16
in the switch stack 21-18
modes 21-19
monitoring 21-23
multicast television application 21-16
setting global parameters 21-19
support for 1-3
MVRoT, guidelines 21-18
MVR over trunk ports
See MVRoT
N
named IPv4 ACLs 31-14
named IPv6 ACLs 37-3
NameSpace Mapper
See NSM
native VLAN
and IEEE 802.1Q tunneling 13-4
configuring 11-19
default 11-19
NEAT
configuring 8-22
overview 8-9
neighbor discovery, IPv6 36-4
neighbor discovery/recovery, EIGRP 35-35
neighbor offset numbers, REP 17-4
neighbors, BGP 35-56
Network Edge Access Toplogy
See NEAT
network management
CDP 23-1
RMON 27-1
SNMP 29-1
network node interface
See NNI
network performance, measuring with IP SLAs 39-3
network policy TLV 24-7
Network Time Protocol
See NTP
NNI
configuring 9-14
described 9-2
protocol control packets on 32-1
no commands 2-4
non-IP traffic filtering 31-26
Nonstop Forwarding Awareness
See NSF Awareness
nontrunking mode 11-15
no power-supply dual command 5-19
normal-range VLANs
characteristics 11-3
configuring 11-7
defined 11-1
no switchport command 9-5
not-so-stubby areas
See NSSA
NSAPs, as ISO IGRP addresses 35-62
NSF Awareness
BGP 35-46
EIGRP 35-37
IS-IS 35-64
OSPF 35-25
NSM 4-3
NSSA, OSPF 35-29
To Next Page
Loading...
