Index
IN-38
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
REP (continued)
neighbor offset numbers 17-4
open segment 17-2
ports 17-6
preempt delay time 17-5
primary edge port 17-4
ring segment 17-2
secondary edge port 17-4
segments 17-1
characteristics 17-2
SNMP traps, configuring 17-13
supported interfaces 17-1
triggering VLAN load balancing 17-5
verifying link integrity 17-3
VLAN blocking 17-12
VLAN load balancing 17-4
report suppression, IGMP
described 21-6
disabling 21-14
resequencing ACL entries 31-14
resets, in BGP 35-49
resetting a UDLD-shutdown interface 25-6
Resilient Ethernet ProtocolLSee REP
responder, IP SLAs
described 39-4
enabling 39-7
response time, measuring with IP SLAs 39-4
restricting access
NTP services 5-8
overview 7-1
passwords and privilege levels 7-2
RADIUS 7-17
TACACS+ 7-10
retry count, VMPS, changing 11-27
reverse address resolution 35-7
Reverse Address Resolution Protocol
See RARP
RFC
1112, IP multicast and IGMP 21-2
1157, SNMPv1 29-2
1305, NTP 5-2
1587, NSSAs 35-23
1757, RMON 27-2
1901, SNMPv2C 29-2
1902 to 1907, SNMPv2 29-2
2236, IP multicast and IGMP 21-2
2273-2275, SNMPv3 29-2
2475, DSCP 33-9
2597, AF per-hop behavior 33-9
2598, EF 33-9
RIP
advertisements 35-18
authentication 35-20
configuring 35-19
default configuration 35-18
described 35-18
for IPv6 36-6
hop counts 35-18
summary addresses 35-21
support for 1-9
RMON
default configuration 27-3
displaying status 27-6
enabling alarms and events 27-3
groups supported 27-2
overview 27-1
statistics
collecting group Ethernet 27-5
collecting group history 27-5
support for 1-10
root guard
described 16-4
enabling 16-10
support for 1-5
To Next Page
Loading...
