Cisco N9K-C93180YC-FX - Verifying FC NPV; Enabling Disruptive Load Balancing

PurposeCommand or Action
To map the server interface to a
different uplink, the server interface
must be shut down before configuring
the traffic map.
Note
Removes the mapping between the specified
server interfaces and NP uplink interfaces.
switch(config)# no npv traffic-map
server-interface {fc slot/port | vfc vfc-id}
external-interface { fc slot/port |
Step 3
san-port-channel <number> | vfc vfc-id |
vfc-port-channel vfc-port-channel-id }
Enabling Disruptive Load Balancing
If you configure additional NP uplinks, you can enable the disruptive load-balancing feature to distribute the
server traffic load evenly among all the NP uplinks.
To enable disruptive load balancing, perform this task:
Procedure
PurposeCommand or Action
Enters configuration mode on the NPV.switch# configure terminal
Step 1
Enables disruptive load balancing on the
switch.
switch(config)# npv auto-load-balance
disruptive
Step 2
Disables disruptive load balancing on the
switch.
switch (config)# no npv auto-load-balance
disruptive
Step 3
Verifying FC NPV
To display information about FC NPV, perform the following task:
Procedure
PurposeCommand or Action
switch# show feature-set | i fcoe
Step 1
Example:
switch# show feature-set | i fcoe
fcoe-npv 8 enabled
Cisco Nexus 9000 Series NX-OS FC NPV Configuration Guide
19
Configuring N Port Virtualization
Verifying FC NPV