Cisco NCS 4200 Series - Configuring a MAC Address Deny List

PurposeCommand or Action
Returns to user EXEC mode.end
Example:
Device(config-if-srv)# end
Step 13
Configuring a MAC Address Deny List
Perform this task to configure a list of MAC addresses that are not allowed on a service instance that is a
member of a bridge domain.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
service instance id ethernet
5.
encapsulation dot1q vlan-id
6.
bridge-domain bridge-id
7.
mac security address deny mac-address
8.
mac security address deny mac-address
9.
mac security address deny mac-address
10.
mac security address deny mac-address
11.
mac security address deny mac-address
12.
mac security
13.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Layer 2 Configuration Guide for Cisco NCS 4200 Series
49
Configuring MAC Address Security on Service Instances and EVC Port Channels
Configuring a MAC Address Deny List