Cisco NCS 4200 Series - Displaying the MAC Security Status of a Specific Service Instance

PurposeCommand or Action
Binds the service instance to a bridge- domain instance
where bridge-id is the identifier for the bridge- domain
instance.
bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 200
Step 6
Sets up a MAC address to be declared as a sticky MAC
address on the service instance.
mac security sticky address mac-address
Example:
Device(config-if-srv)# mac security sticky
address 1111.2222.3333
Step 7
Enables MAC security on the service instance.mac security
Example:
Device(config-if-srv)# mac security
Step 8
Returns to user EXEC mode.end
Example:
Device(config-if-srv)# end
Step 9
Displaying the MAC Security Status of a Specific Service Instance
Perform this task to display the MAC security status of a service instance.
SUMMARY STEPS
1.
enable
2.
show ethernet service instance id id interface type number mac security
3.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Layer 2 Configuration Guide for Cisco NCS 4200 Series
58
Configuring MAC Address Security on Service Instances and EVC Port Channels
Displaying the MAC Security Status of a Specific Service Instance