Cisco NCS 4200 Series - Verifying Configured Static MAC Addresses on a Service Instance

Router(config-if)# service instance 1 ethernet
Router(config-if-srv)# encapsulation dot1q 100
Router(config-if-srv)# bridge-domain 100
Router(config-if-srv)# mac static address 0000.bbbb.cccc
Router(config-if-srv)# exit
Verifying Configured Static MAC Addresses on a Service
Instance
Use one or more of the following commands to verify the configured static MAC address on a service instance:
•
show bridge-domain
Example: Verifying Configured Static MAC Addresses on a Service Instance
show bridge-domain
The sample output for the show bridge-domain command:
Router# show bridge-domain 10 mac static address
Bridge-Domain ID : 10
Static MAC count : System : 1, bridge-domain : 1
Port Address Action
Gi0/3/7 ServInst 10 aaa1.123c.bc32
Layer 2 Configuration Guide for Cisco NCS 4200 Series
74
Static MAC Address Support on Service Instances
Verifying Configured Static MAC Addresses on a Service Instance