EasyManua.ls Logo

Cisco Nexus 1000V - Problems with the Cisco Nexus 1000 V Installation Management Center

Cisco Nexus 1000V
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PurposeCommand
Displays mappings between the virtual Ethernet and
VMware DVPort.
show interface virtual port-mapping [vm [name] |
vmk | vswif | description] [module_num]
Example: show interface vethernet
This example shows how to display vEthernet 1:
switch# show interface veth1
Vethernet1 is up
Port description is gentoo1, Network Adapter 1
Hardware is Virtual, address is 0050.56bd.42f6
Owner is VM "gentoo1", adapter is Network Adapter 1
Active on module 33
VMware DVS port 100
Port-Profile is vlan48
Port mode is access
Rx
491242 Input Packets 491180 Unicast Packets
7 Multicast Packets 55 Broadcast Packets
29488527 Bytes
Tx
504958 Output Packets 491181 Unicast Packets
1 Multicast Packets 13776 Broadcast Packets 941 Flood Packets
714925076 Bytes
11 Input Packet Drops 0 Output Packet Drops
switch#
Example: show interface virtual
This example shows how to display information for all vEthernet interfaces:
switch# show interface virtual
--------------------------------------------------------------------------------
Port Adapter Owner Mod Host
--------------------------------------------------------------------------------
Veth1 Vm1-kl61 2
Veth2 VM1-kl65 5
Veth3 VM2-kl61 2
Veth1 Net Adapter 1 austen-gentoo1 33 austen-strider.austen.
Veth2 Net Adapter 2 austen-gentoo1 33 austen-strider.austen.
switch#
Example: show interface virtual description
This example shows how to display the descriptions for all vEthernet interfaces:
switch# show interface virtual description
--------------------------------------------------------------------------------
Interface Description
--------------------------------------------------------------------------------
Veth1 gentoo1, Network Adapter 1
Veth2 gentoo1, Network Adapter 2
Veth3 VMware VMkernel, vmk1
Veth4 VMware Service Console, vswif1
switch#
Example: show interface virtual port-mapping
This example shows how to display the virtual port mapping for all vEthernet interfaces:
switch# show interface virtual port-mapping
-------------------------------------------------------------------------------
Port Hypervisor Port Binding Type Status Reason
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
42
Configuring Virtual Ethernet Interfaces
Verifying the vEthernet Interface Configuration

Table of Contents

Other manuals for Cisco Nexus 1000V

Related product manuals