Cisco Nexus 1000V - Removing a Port Channel Group from a Port Profile

PurposeCommand or Action
backup—Optionally specifies an ordered list of
backup subgroups for pinning to be used if the
primary subgroup is not available.
(Optional)
Displays the pinning configuration of the specified
interface.
switch(config-if)# show running-config
interface vethernet interface-number
Step 4
(Optional)
Displays the pinning configuration on the specified
VEM.
switch(config-if)# module vem
module_number execute vemcmd show
pinning
Step 5
(Optional)
Displays the VSM configured pinning subgroups.
switch(config-if)# module vem
module_number execute vemcmd show
static pinning config
Step 6
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config-if)# copy running-config
startup-config
Step 7
This example shows how to pin subgroup ID 0 to vEthernet interface 1:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# pinning id 0
switch(config-if)# show running-config interface vethernet 1
version 4.0(4)SV1(2)
interface Vethernet3
service-policy type qos input policy1
pinning id 0
switch(config-if)# exit
switch(config)# exit
switch# module vem 3 execute vemcmd show pinning
LTL IfIndex PC_LTL VSM_SGID VEM_SGID Eff_SGID
48 1b040000 304 0 0 0
switch#
This example shows the output after configuring backup subgroups for pinning:
switch(config-if)# module vem 4 execute vemcmd show static pinning config
LTL IfIndex VSM_SGID Backup_SGID
48 1c0000a0 0, 1,2
50 1c000100 0, 1
switch(config-if)# copy running-config startup-config
Removing a Port Channel Group from a Port Profile
You can remove a port channel group from a port profile.
Before You Begin
Log in to the CLI in EXEC mode.
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
73
Configuring Port Channels
Removing a Port Channel Group from a Port Profile