Cisco Nexus 3000 series - Page 120

Send document comments to nexus3k-docfeedback@cisco.com
4-18
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Chapter 4 Configuring EIGRP
Configuring Advanced EIGRP
2. router eigrp instance-tag
3. address-family ipv4 unicast
4. redistribute {bgp as | {eigrp | ospf | ospfv3 | rip} instance-tag | direct | static} route-map name
5. default-metric bandwidth delay reliability loading mtu
6. show ip eigrp route-map statistics redistribute
7. (Optional) copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
router eigrp instance-tag
Example:
switch(config)# router eigrp Test1
switch(config-router)#
Creates a new EIGRP process with the
configured instance tag. The instance tag can
be any case-sensitive, alphanumeric string up
to 20 characters.
If you configure an instance-tag that does not
qualify as an AS number, you must use the
autonomous-system command to configure
the AS number explicitly or this EIGRP
instance will remain in the shutdown state.
Step 3
address-family ipv4 unicast
Example:
switch(config-router)# address-family ipv4
unicast
switch(config-router-af)#
Enters the address-family configuration mode.
This command is optional for IPv4.
Step 4
redistribute {bgp as | {eigrp | ospf | ospfv3 |
rip}
instance-tag | direct | static} route-map
name
Example:
switch(config-router-af)# redistribute bgp 100
route-map BGPFilter
Injects routes from one routing domain into
EIGRP. The instance tag and map name can be
any case-sensitive, alphanumeric string up to
20 characters.
Step 5
default-metric bandwidth delay reliability
loading mtu
Example:
switch(config-router-af)# default-metric
500000 30 200 1 1500
Sets the metrics assigned to routes learned
through route redistribution. The default
values are as follows:
• bandwidth—100000 Kb/s
• delay—100 (10 microsecond units)
• reliability—255
• loading—1
• MTU—1492