Cisco Nexus 3000 series - Page 185

Send document comments to nexus3k-docfeedback@cisco.com
6-29
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release5.0(3)U1(1)
Chapter 6 Configuring Advanced BGP
Configuring Advanced BGP
3. neighbor ipaddress remote-as as-number
4. address-family ipv4 {unicast | multicast}
5. advertise-map adv-map {exist-map exist-rmap | non-exist-map nonexist-rmap}
6. (Optional) show ip bgp neighbor
7. (Optional) copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
router bgp as-number
Example:
switch(config)# router bgp 65536
switch(config-router)#
Enters BGP mode and assigns the autonomous system
number to the local BGP speaker.
Step 3
neighbor ip-address remote-as as-number
Example:
switch(config-router)# neighbor
192.168.1.2 remote-as 65537
switch(config-router-neighbor)#
Places the router in neighbor configuration mode for
BGP routing and configures the neighbor IP address.
Step 4
address-family ipv4 {unicast |
multicast}
Example:
switch(config-router-neighbor)#
address-family ipv4 multicast
switch(config-router-neighbor-af)#
Enters address family configuration mode.