Cisco Nexus 3000 series - Page 210

Send document comments to nexus3k-docfeedback@cisco.com
7-14
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Chapter 7 Configuring RIP
Configuring RIP
5. vrf context vrf_name
6. (Optional) address-family ipv4 unicast
7. (Optional) redistribute {bgp as | direct | {eigrp | ospf | ospfv3 | rip} instance-tag | static}
route-map map-name
8. interface ethernet slot/port
9. no switchport
10. vrf member vrf-name
11. ip-address ip-prefix/length
12. ip router rip instance-tag
13. (Optional) show ip rip [instance instance-tag] interface [interface-type slot/port] [vrf vrf-name]
14. (Optional) copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
vrf vrf-name
Example:
switch(config)# vrf RemoteOfficeVRF
switch(config-vrf)#
Creates a new VRF.
Step 3
exit
Example:
switch(config-vrf)# exit
switch(config)#
Exits VRF configuration mode.
Step 4
router rip instance-tag
Example:
switch(config)# router rip Enterprise
switch(config-router)#
Creates a new RIP instance with the configured
instance tag.
Step 5
vrf context vrf-name
Example:
switch(config)# vrf context
RemoteOfficeVRF
switch(config-vrf)#
Creates a new VRF and enters VRF configuration
mode.
Step 6
address-family ipv4 unicast
Example:
switch(config-router-vrf)#
address-family ipv4 unicast
switch(config-router-vrf-af)#
(Optional) Configures the VRF address family for this
RIP instance.