Cisco Nexus 3000 series - Verifying the RIP Configuration; Displaying RIP Statistics

Send document comments to nexus3k-docfeedback@cisco.com
7-17
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release5.0(3)U1(1)
Chapter 7 Configuring RIP
Verifying the RIP Configuration
Verifying the RIP Configuration
To display the RIP configuration information, perform one of the following tasks:
Displaying RIP Statistics
To display the RIP statistics, use the following commands:
Use the clear ip rip policy command to clear policy statistics.
Use the clear ip rip statistics command to clear RIP statistics.
Command Purpose
ip rip metric-offset value
Example:
switch(config-if)# ip rip metric-offset 10
Adds a value to the metric for every router received
on this interface. The range is from 1 to 15. The
default is 1.
ip rip route-filter {prefix-list list-name
| route-map
map-name | [in | out]
Example:
switch(config-if)# ip rip route-filter
route-map InputMap in
Specifies a route map to filter incoming or outgoing
RIP updates.
Command Purpose
show ip rip instance [instance-tag] [vrf
vrf-name]
Displays the status for an instance of RIP.
show ip rip [instance instance-tag] interface
slot/port detail [vrf vrf-name]
Displays the RIP status for an interface.
show ip rip [instance instance-tag] neighbor
[interface-type number] [vrf vrf-name]
Displays the RIP neighbor table.
show ip} rip [instance instance-tag] route
[ip-prefix/lengh [longer-prefixes |
shorter--prefixes]] [summary] [vrf vrf-name]
Displays the RIP route table.
show running-configuration rip Displays the current running RIP configuration.
Command Purpose
show ip rip [instance instance-tag] policy
statistics redistribute {bgp as | direct |
{eigrp | ospf | ospfv3 | rip} instance-tag |
static} [vrf vrf-name]
Displays the RIP policy status.
show ip rip [instance instance-tag]
statistics interface-type number] [vrf
vrf-name]
Displays the RIP statistics.