Cisco Nexus 3000 series - CHAPTER 11 Configuring Route Policy Manager; Information about Route Policy Manager

CHAPTER
Send document comments to nexus3k-docfeedback@cisco.com
11-1
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release5.0(3)U1(1)
11
Configuring Route Policy Manager
This chapter describes how to configure the Route Policy Manager on the Cisco NX-OS switch.
This chapter includes the following sections:
• Information About Route Policy Manager, page 11-1
• Licensing Requirements for Route Policy Manager, page 11-5
• Guidelines and Limitations, page 11-5
• Default Settings, page 11-5
• Configuring Route Policy Manager, page 11-6
• Verifying the Route Policy Manager Configuration, page 11-17
• Configuration Examples for Route Policy Manager, page 11-17
• Related Topics, page 11-18
• Additional References, page 11-18
• Feature History for Route Policy Manager, page 11-18
Information About Route Policy Manager
Route Policy Manager supports route maps and IP prefix lists. These features are used for route
redistribution. A prefix list contains one or more IPv4 network prefixes and the associated prefix length
values. You can use a prefix list by itself in features such as Border Gateway Protocol (BGP) templates,
route filtering, or redistribution of routes that are exchanged between routing domains.
Route maps can apply to both routes and IP packets. Route filtering and redistribution pass a route
through a route map.
This section includes the following topics:
• Prefix Lists, page 11-2
• Route Maps, page 11-2
• Route Redistribution and Route Maps, page 11-5