Cisco Nexus 3000 series - Ip Access-List (Session)

Send comments to nexus3k-docfeedback@cisco.com
-SM-88
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ip access-list (session)
ip access-list (session)
To create an IPv4 access control list (ACL) within a configuration session, use the ip access-list
command. To remove an ACL from a configuration session, use the no form of this command.
ip access-list ACL-name
no ip access-list ACL-name
Syntax Description
Command Default No IPv4 ACLs are defined by default.
Command Modes Global session configuration mode
Command History
Examples This example shows how to create an IPv4 ACL for a configuration session:
switch# configure session MySession1
switch(config-s)# ip access-list myACL
switch(config-s-acl)#
Related Commands
Command Description
reload Reloads the Cisco Nexus 3000 Series switch software.
ACL-name Name of the IPv4 ACL. The name can be up to 64 alphanumeric characters
and cannot contain a space or quotation mark.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
configure session Creates a configuration session.
deny Configures a deny rule in an IPv4 ACL.
permit Configures a permit rule in an IPv4 ACL.
show configuration
session
Displays the contents of the session.