Cisco Nexus 3000 series - Logging Event

Send comments to nexus3k-docfeedback@cisco.com
-SM-102
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging event
logging event
To log interface events, use the logging event command. To disable logging of interface events, use the
no form of this command.
logging event {link-status | trunk-status} {default | enable}
no logging event {link-status | trunk-status} {default | enable}
Syntax Description
Command Default None
Command Modes Global configuration mode
Switch profile configuration mode
Command History
Examples This example shows how to log interface events:
switch# configure terminal
switch(config)# logging event link-status default
switch(config)#
This example shows how to log TRUNK interface events in a switch profile:
switch# configure sync
Enter configuration commands, one per line. End with CNTL/Z.
switch(config-sync)# switch-profile s5010
Switch-Profile started, Profile ID is 1
switch(config-sync-sp)# logging event trunk-status default
switch(config-sync-sp)#
Related Commands
link-status Specifies to log all UP/DOWN and CHANGE messages.
trunk-status Specifies to log all TRUNK status messages.
default Specifies to the default logging configuration is used by interfaces not
explicitly configured.
enable Enables the logging to override the port level configuration.
Release Modification
5.0(3)U1(1) This command was introduced.
5.0(3)U2(1) Support to log interface events was added in switch profiles.
Command Description
show logging Displays the logging status.
show switch-profile Displays information about the switch profile and the configuration revision.
switch-profile Creates or configures a switch profile.