Cisco Nexus 3000 series - Ntp Authenticate

Send comments to nexus3k-docfeedback@cisco.com
-SM-132
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ntp authenticate
ntp authenticate
To enable Network Time Protocol (NTP) authentication, use the ntp authenticate command. To disable
NTP authentication, use the no form of this command.
ntp authenticate
no ntp authenticate
Syntax Description This command has no arguments or keywords.
Defaults Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable NTP authentication:
switch(config)# ntp authenticate
switch(config)#
This example shows how to disable NTP authentication:
switch(config)# no ntp authenticate
switch(config)#
Release Modification
6.0(2)U(2)1 This command was introduced.