Cisco Nexus 3000 series - Ptp Delay-Request Minimum Interval

Send comments to nexus3k-docfeedback@cisco.com
-SM-160
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ptp delay-request minimum interval
ptp delay-request minimum interval
To configure the minimum interval allowed between Precision Time Protocol (PTP) delay-request
messages when the port is in the master state, use the ptp delay-request minimum interval command.
To remove the minimum interval configuration for PTP delay-request messages, use the no form of this
command.
ptp delay-request minimum interval seconds
no ptp delay-request minimum interval seconds
Syntax Description
Command Default None
Command Modes Interface configuration mode
Command History
Usage Guidelines Make sure that you have globally enabled PTP on the switch and configured the source IP address for
PTP communication.
This command does not require a license.
Examples This example shows how to configure the minimum interval allowed between PTP delay-request
messages:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# ptp delay-request minimum interval 3
switch(config-if)#
This example shows how to remove the minimum interval configuration for PTP delay-request
messages:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no ptp delay-request minimum interval 3
switch(config-if)#
Related Commands
seconds Log seconds. The range is from -1 to 6.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
feature ptp Enables or disables PTP on the device.
ptp Enables or disables PTP on an interface.