Cisco Nexus 3000 series - Action Cli

Send comments to nexus3k-docfeedback@cisco.com
-SM-4
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
action cli
action cli
To configure a virtual shell (VSH) command string to be executed when an Embedded Event Manager
(EEM) applet is triggered, use the action cli command. To disable the VSH command string, use the no
form of this command.
action label num1 [.num2] cli [local] vsh_cmd
no action label num1 [.num2] cli
Syntax Description
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a VSH command string to be executed when an EEM applet is
triggered:
switch# configure terminal
switch(config)# event manager applet cli-applet
switch(config-applet)# action 1.1 cli show version
switch(config-applet)#
Related Commands
label num1 [.num2] Unique identifier that can be any string value. Actions are sorted and run in an
ascending alphanumeric sequence using the label as the sort key. The range for
num1 is from 1 to 16 and the range for num2 is from 0 to 9.
local (Optional) Specifies the action is to be executed in the same module on which the
event occurs.
vsh_cmd VSH command string to be executed when the applet is triggered.
Release Modification
5.0(3)U3(1) This command was introduced.
Command Description
action counter Sets or modifies a named counter when an Embedded Event Manager
(EEM) applet is triggered.
action event-default Specifies that the default action for the event is to be performed when an
Embedded Event Manager (EEM) applet is triggered.
action policy-default Enables the default action of the policy being overridden.