Cisco Nexus 3000 series - Snmp-Server Enable Traps Vtp

Send comments to nexus3k-docfeedback@cisco.com
-SM-308
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
snmp-server enable traps vtp
snmp-server enable traps vtp
To enable the Simple Network Management Protocol (SNMP) notifications for a VLAN Trunking
Protocol (VTP) domain, use the snmp-server enable traps vtp command. To disable SNMP
notifications on a VTP domain, use the no form of this command.
snmp-server enable traps vtp
no snmp-server enable traps vtp
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines The snmp-server enable traps command enables both traps and informs, depending on the configured
notification host receivers.
This command does not require a license.
Examples This example shows how to enable SNMP notifications on a VTP domain:
switch(config)# snmp-server enable traps vtp
switch(config)#
This example shows how to disable all SNMP notifications on a VTP domain:
switch(config)# no snmp-server enable traps vtp
switch(config)#
Related Commands
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
show snmp trap Displays the SNMP notifications enabled or disabled.
show vtp status Displays VTP information.