Cisco Nexus 3000 series - Snmp-Server User

Send comments to nexus3k-docfeedback@cisco.com
-SM-316
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
snmp-server user
snmp-server user
To configure a new user to a Simple Network Management Protocol (SNMP) group, use the
snmp-server user command. To remove a user from an SNMP group, use the no form of this command.
snmp-server user username [groupname] [auth {md5 | sha} auth-password [{engineID engine-ID
| localizedkey | priv {priv-password | aes-128}}]]
no snmp-server user
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Examples This example shows how to configure an SNMP user named authuser with authentication and privacy
parameters:
switch# configure terminal
username Name of the user on the host that connects to the agent. The name can be a
maximum of 32 alphanumeric characters.
groupname (Optional) Name of the group to which the user is associated. The name can
be a maximum of 32 alphanumeric characters.
auth (Optional) Specifies that an authentication level setting will be initiated for
the session.
md5 (Optional) Specifies that the HMAC-MD5-96 authentication level be used
for the session.
sha (Optional) Specifies that the HMAC-SHA-96 authentication level be used
for the session.
auth-password (Optional) Authentication password for the user that enables the agent to
receive packets from the host. The password can be a maximum of 130
characters.
engineID engine-ID (Optional) Specifies the SNMP engine ID.
localizedkey (Optional) Specifies whether the passwords are in localized key format.
priv (Optional) Initiates a privacy authentication level setting session.
priv-password (Optional) Privacy password for the user that enables the host to encrypt the
content of the message that it sends to the agent. The password can be a
maximum of 130 characters.
aes-128 (Optional) Specifies that a 128-bit AES algorithm for privacy be used for
the session.
Release Modification
5.0(3)U1(1) This command was introduced.