Cisco Nexus 3000 series - Alert-Group (Call Home)

Send comments to nexus3k-docfeedback@cisco.com
-SM-18
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
alert-group (Call Home)
alert-group (Call Home)
To configure a CLI show command for an alert group, use the alert-group command. To remove a CLI
command from an alert group, use the no form of this command.
alert-group alert user-def-cmd CLI-command
no alert-group alert user-def-cmd CLI-command
Syntax Description
Command Default None
Command Modes Callhome configuration mode
Command History
Usage Guidelines You can customize predefined alert groups to execute additional CLI show commands when specific
events occur and send that show output with the Call Home message. You can assign a maximum of five
user-defined CLI show commands to an alert group.
You must enclose the show command in double quotes. Only valid show commands are accepted.
alert Alert group. The alert group can be one of the following:
• All—All alert groups
• Cisco-TAC—Cisco TAC events
• Configuration—Configuration events
• Diagnostic—Diagnostic events
• EEM—EEM events
• Environmental—Power, fan, temperature-related events
• Inventory—Inventory status events
• License—Licensing events
• Linecard-Hardware—Linecard-related events
• Supervisor-Hardware—Supervisor-related events
• Syslog-group-port—Syslog message events filed by port manager
• System—Software-related events
• Tes t—User-generated test events
user-def-cmd Specifies a CLI command for an alert group.
CLI-command CLI show command. The command can be a maximum of 512 characters.
Release Modification
5.0(3)U1(1) This command was introduced.