Cisco Nexus 3000 series - Destination Interface (ERSPAN)

Send comments to nexus3k-docfeedback@cisco.com
-SM-45
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
destination interface (ERSPAN)
destination interface (ERSPAN)
To configure interfaces for an Encapsulated Remote Switched Port Analyzer (ERSPAN) destination, use
the destination interface command. To remove the interfaces from an ERSPAN session, use the no form
of this command.
destination interface ethernet slot/port
no destination interface ethernet slot/port
Syntax Description
Command Default None
Command Modes ERSPAN destination configuration mode
Command History
Usage Guidelines The destination port should be previously configured as a switchport monitor.
This command does not require a license.
Examples This example shows how to configure an ERSPAN destination interface:
switch# configure terminal
switch(config)# monitor session 1 type erspan-destination
switch(config-erspan-dst)# destination interface ethernet 1/5
switch(config-erspan-dst)#
Related Commands
ethernet Specifies the Ethernet interface.
slot/port Ethernet interface slot number and port number. The slot number is from 1
to 255, and the port number is from 1 to 128.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
monitor session Creates a new SPAN session configuration.
show monitor session Displays SPAN session configuration information.
show running-config
monitor
Displays the running configuration information of a SPAN session.
source (SPAN session) Configures a source SPAN port.
source (ERSPAN
session)
Configures a source VLAN interface.