Cisco Nexus 3000 series - Event Storm-Control

Send comments to nexus3k-docfeedback@cisco.com
-SM-69
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event storm-control
event storm-control
To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
storm-control, use the event storm-control command. To remove the storm-control event criteria, use
the no form of this command.
event storm-control
no event storm-control
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to specify that an EEM applet runs when a storm-control occurs:
switch# configure terminal
switch(config) event manager applet cli-event
switch(config-applet)# event storm-control
switch(config-applet)#
Release Modification
5.0(3)U3(1) This command was introduced.