Cisco Nexus 3000 series - Preparing to Install the Chassis; Equipment Grounding and Clearance; Lifting and Rack-Mounting Precautions; Overheating Prevention

Screw (4)2L-bracket (4)1
Step 2 Use screws to attach the brackets to a flat surface.
Attaching Magnet to the Chassis
You attach the magnet to the bottom of the chassis. The magnet holds the chassis in place on a flat surface.
Before you begin
• You must have the following equipment:
• Chassis magnet
Step 1 Align the magnet to the bottom of the chassis. Attach the magnet to the chassis. See the following figure.
Installing the Switch Chassis
4
Installing the Switch Chassis
Attaching Magnet to the Chassis