Step 2 Attach two front-mount brackets to the sides of the chassis as follows:
a) Align the two holes in one side of a front-mount bracket to two holes on the left or right side of the chassis as shown
in the following figure.
Figure 25: Aligning and attaching Front-Mount Brackets to the Chassis
2 M4 x 6 mm screws2Front rack-mount bracket1
b) Use two M4 x 6 mm screws to attach the bracket to the chassis and tighten each screw to 12 in-lb (1.36 N·m) of
torque.
c) Repeat Steps 2a and 2b to attach the other front-mount bracket to the other side of the chassis.
Step 3 Install the chassis in the rack as follows:
a) Slide the power supply end of the chassis onto the installed bottom-support rails as shown in the following figure.
When you have fully pushed the chassis all the way onto the bottom-support rails, the chassis stops on the
bottom-support rails insert into the chassis notches and the front-mount brackets touch the front vertical mounting
rails.
Cisco Nexus 3000 Series Hardware Installation Guide
44
Installing the Chassis
Installing a 2 (RU) Chassis in a Four-Post Rack
To Next Page
Loading...
