switch(config)# snmp-server community comm group network-admin
switch(config)#
The following SNMPv3 example shows how to use a v3 username and password:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# snmp-server context def vrf default
switch(config)#
Enabling SNMP Notifications
You can enable or disable notifications. If you do not specify a notification name, Cisco NX-OS enables all
notifications.
The snmp-server enable traps CLI command enables both traps and informs, depending on the configured
notification host receivers.
Note
The following table lists the CLI commands that enable the notifications for Cisco NX-OS MIBs.
Table 20: Enabling SNMP Notifications
Related CommandsMIB
snmp-server enable trapsAll notifications
snmp-server enable traps bridge newroot
snmp-server enable traps bridge topologychange
BRIDGE-MIB
snmp-server enable traps aaaCISCO-AAA-SERVER-MIB
snmp-server enable traps entity
snmp-server enable traps entity fru
ENITY-MIB,
CISCO-ENTITY-FRU-CONTROL-MIB,
CISCO-ENTITY-SENSOR-MIB
snmp-server enable traps licenseCISCO-LICENSE-MGR-MIB
snmp-server enable traps linkIF-MIB
snmp-server enable traps port-securityCISCO-PSM-MIB
snmp-server enable traps snmp
snmp-server enable traps snmp authentication
SNMPv2-MIB
snmp-server enable traps fccCISCO-FCC-MIB
snmp-server enable traps fcdomainCISCO-DM-MIB
snmp-server enable traps fcnsCISCO-NS-MIB
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
102
Configuring SNMP
Enabling SNMP Notifications
To Next Page
Loading...
