switch# configure terminal
switch(config)# logging console 3
The following example shows how to display the console logging configuration:
switch# show logging console
Logging console: enabled (Severity: error)
The following example shows how to disable logging for the console:
switch# configure terminal
switch(config)# no logging console
The following example shows how to configure a logging level of 4 for the terminal session:
switch# terminal monitor
switch# configure terminal
switch(config)# logging monitor 4
The following example shows how to display the terminal session logging configuration:
switch# show logging monitor
Logging monitor: enabled (Severity: warning)
The following example shows how to disable logging for the terminal session:
switch# configure terminal
switch(config)# no logging monitor
Configuring System Message Logging to a File
You can configure the switch to log system messages to a file. By default, system messages are logged to the
file log:messages.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Configures the name of the log file used to store
system messages and the minimum severity
switch(config)# logging logfile logfile-name
severity-level [size bytes]
Step 2
level to log. You can optionally specify a
maximum file size. The default severity level
is 5 and the file size is 4194304.
Severity levels range from 0 to 7:
• 0 – emergency
• 1 – alert
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
39
Configuring System Message Logging
Configuring System Message Logging to a File
To Next Page
Loading...
