PurposeCommand or Action
management values for the virtual routing
and forwarding (VRF) name. If a specific
VRF is not identified, management is the
default. However, if management is
configured, it will not be listed in the
output of the show-running command
because it is the default. If a specific VRF
is configured, the show-running command
output will list the VRF for each server.
The current Cisco Fabric
Services (CFS) distribution
does not support VRF. If CFS
distribution is enabled, the
logging server configured with
the default VRF is distributed
as the management VRF.
Note
• The facility argument names the syslog
facility type. The default outgoing facility
is local7.
The facilities are listed in the command
reference for the Cisco Nexus Series
software that you are using.
Debugging is a CLI facility but the
debug syslogs are not sent to the
server.
Note
Removes the logging server for the specified
host.
(Optional) no logging server host
Example:
Step 3
switch(config)# no logging server
172.28.254.254 5
Displays the syslog server configuration.(Optional) show logging server
Example:
Step 4
switch# show logging server
Saves the change persistently through reboots
and restarts by copying the running
configuration to the startup configuration.
(Optional) copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Step 5
Example
The following examples show how to configure a syslog server:
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
44
Configuring System Message Logging
Configuring Syslog Servers
To Next Page
Loading...
