Cisco Nexus 3548 series - Configuring DOM Logging

Configuring DOM Logging
Enabling DOM Logging
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enables transceiver digital optical monitoring
periodic polling.
switch(config)# system ethernet dom polling
Step 2
Example
The following example shows how to enable DOM logging.
switch# configure terminal
switch(config)# system ethernet dom polling
Disabling DOM Logging
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Disables transceiver digital optical monitoring
periodic polling.
switch(config)# no system ethernet dom
polling
Step 2
Example
The following example shows how to disable DOM logging.
switch# configure terminal
switch(config)# no system ethernet dom polling
Verifying the DOM Logging Configuration
PurposeCommand
Displays the transceiver digital optical monitoring
periodic polling status.
show system ethernet dom polling status
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
48
Configuring System Message Logging
Configuring DOM Logging