Cisco Nexus 5000 Series - Show Interface Debounce

show interface debounce
To display the debounce time information for all interfaces, use the show interface debounce command.
show interface debounce
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Examples
This example shows how to display the debounce status of all interfaces:
switch# show interface debounce
--------------------------------------------------------------------------------
Port Debounce time Value(ms)
--------------------------------------------------------------------------------
Eth1/1 enable 100
Eth1/2 enable 100
Eth1/3 enable 100
Eth1/4 enable 100
Eth1/5 enable 100
Eth1/6 enable 100
Eth1/7 enable 100
Eth1/8 enable 100
Eth1/9 enable 100
Eth1/10 enable 100
Eth1/11 enable 100
Eth1/12 enable 100
Eth1/13 enable 100
Eth1/14 enable 100
Eth1/15 enable 100
Eth1/16 enable 100
Eth1/17 enable 100
Eth1/18 enable 100
Eth1/19 enable 100
Eth1/20 enable 100
Eth1/21 enable 100
Eth1/22 enable 100
Eth1/23 enable 100
Eth1/24 enable 100
Eth1/25 enable 100
Eth1/26 enable 100
Eth1/27 enable 100
Eth1/28 enable 100
Eth1/29 enable 100
Eth1/30 enable 100
Eth1/31 enable 100
Cisco Nexus 5000 Series Interfaces Command Reference
113
Show Commands
show interface debounce