Cisco Nexus 5000 Series - Page 126

ModificationRelease
Support for Layer 3 interfaces and subinterfaces, and Adapter Fabric
Extender (Adapter-FEX) was added.
The switchport keyword was added.
5.0(3)N1(1)
Usage Guidelines
If the interface and transceiver speed is mismatched, the SFP validation failed message is displayed when you
enter the show interface ethernet slot /port command. For example, if you insert a 1-Gigabit SFP transceiver
into a port without configuring the speed 1000 command, you will get this error.
By default, all ports on a Cisco Nexus 5000 Series switch are 10 Gigabits.
Examples
This example shows how to display the detailed configuration of the specified interface:
switch# show interface ethernet 1/1
Ethernet1/1 is up
Hardware: 1000/10000 Ethernet, address: 000d.ece7.df48 (bia 000d.ece7.df48)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is fex-fabric
full-duplex, 10 Gb/s, media type is 1/10g
Beacon is turned off
Input flow-control is off, output flow-control is off
Rate mode is dedicated
Switchport monitor is off
Last link flapped 09:03:57
Last clearing of "show interface" counters never
30 seconds input rate 2376 bits/sec, 0 packets/sec
30 seconds output rate 1584 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 1.58 Kbps, 0 pps; output rate 792 bps, 0 pps
RX
0 unicast packets 10440 multicast packets 0 broadcast packets
10440 input packets 11108120 bytes
0 jumbo packets 0 storm suppression packets
0 runts 0 giants 0 CRC 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
0 unicast packets 20241 multicast packets 105 broadcast packets
20346 output packets 7633280 bytes
0 jumbo packets
0 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble
0 Tx pause
1 interface resets
switch#
This example shows how to display the counters configured on a specified interface:
switch# show interface ethernet 1/1 counters
--------------------------------------------------------------------------------
Port InOctets InUcastPkts InMcastPkts InBcastPkts
--------------------------------------------------------------------------------
Eth1/1 17193136 0 16159 0
--------------------------------------------------------------------------------
Port OutOctets OutUcastPkts OutMcastPkts OutBcastPkts
Cisco Nexus 5000 Series Interfaces Command Reference
116
Show Commands
show interface ethernet