Cisco Nexus 5000 Series - Page 131

Table 2: show interface loopback Field Description
DescriptionField
Indicates whether the interface hardware is currently
active (whether carrier detect is present), is currently
inactive (down), or has been taken down by an
administrator (administratively down).
Loopback is ...
Hardware is Loopback.Hardware
Maximum transmission unit (MTU) of the interface.MTU
Bandwidth (BW) of the interface in kilobits per
second.
BW
Delay (DLY) of the interface in microseconds.DLY
Reliability of the interface as a fraction of 255
(255/255 is 100 percent reliability), calculated as an
exponential average over 5 minutes.
reliability
Load on the interface for transmitting packets as a
fraction of 255 (255/255 is completely saturated),
calculated as an exponential average over 5 minutes.
txload
Load on the interface for receiving packets as a
fraction of 255 (255/255 is completely saturated),
calculated as an exponential average over 5 minutes.
rxload
Encapsulation method assigned to interface.Encapsulation
Indicates whether loopback is set.LOOPBACK
Total number of error-free packets received by the
system.
packets input
Total number of bytes, including data and MAC
encapsulation, in the error-free packets received by
the system.
bytes
Total number of multicast frames enabled on the
interface.
multicast frames
Total number of multicast frames compressed on the
interface.
compressed
Cisco Nexus 5000 Series Interfaces Command Reference
121
Show Commands
show interface loopback