Cisco Nexus 5000 Series - Show Port-Channel Traffic

show port-channel traffic
To display the traffic statistics for EtherChannels, use the show port-channel traffic command.
show port-channel traffic [interface port-channel number [. subinterface-number]]
Syntax Description
(Optional) Displays traffic statistics for a specified
interface.
interface
(Optional) Displays information for a specified
EtherChannel. The range is from 1 to 4096.
port-channel number
(Optional) Subinterface number. Use the
EtherChannel number followed by a dot (.) indicator
and the subinterface number. The format is
portchannel-number.subinterface-number.
.subinterface-number
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Examples
This example shows how to display the traffic statistics for all EtherChannels:
switch# show port-channel traffic
ChanId Port Rx-Ucst Tx-Ucst Rx-Mcst Tx-Mcst Rx-Bcst Tx-Bcst
------ --------- ------- ------- ------- ------- ------- -------
10 Eth1/7 0.0% 0.0% 0.0% 0.0% 0.0% 0.0%
10 Eth1/8 0.0% 0.0% 0.0% 0.0% 0.0% 0.0%
10 Eth1/9 0.0% 0.0% 0.0% 0.0% 0.0% 0.0%
10 Eth1/10 0.0% 0.0% 0.0% 0.0% 0.0% 0.0%
------ --------- ------- ------- ------- ------- ------- -------
4000 Eth1/1 0.0% 0.0% 99.64% 99.81% 0.0% 0.0%
4000 Eth1/2 0.0% 0.0% 0.06% 0.06% 0.0% 0.0%
4000 Eth1/3 0.0% 0.0% 0.23% 0.06% 0.0% 0.0%
4000 Eth1/4 0.0% 0.0% 0.06% 0.06% 0.0% 0.0%
switch#
This example shows how to display the traffic statistics for a specific EtherChannel:
switch# show port-channel traffic interface port-channel 10
ChanId Port Rx-Ucst Tx-Ucst Rx-Mcst Tx-Mcst Rx-Bcst Tx-Bcst
Cisco Nexus 5000 Series Interfaces Command Reference
154
Show Commands
show port-channel traffic