Cisco Nexus 5000 Series - vPC as PIM Designated Router

errdisable detect cause
To enable error-disable (err-disabled) detection in an application, use the errdisable detect cause command.
To disable error disable detection, use the no form of this command.
errdisable detect cause {all| link-flap| loopback}
no errdisable detect cause {all| link-flap| loopback}
Syntax Description
Enables error detection on all cases.all
Enables error disable detection on linkstate-flapping.link-flap
Enables error disable detection on loopback.loopback
Command Default
Enabled
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.4.2(1)N1(1)
Usage Guidelines
When error disable detection is enabled and a cause is detected on an interface, the interface is placed in an
err-disabled state, which is an operational state that is similar to the link-down state.
Examples
This example shows how to enable the err-disabled detection on linkstate-flapping:
switch(config)# errdisable detect cause link-flap
switch(config)#
Related Commands
DescriptionCommand
Configures recovery from the err-disabled state.errdisable recovery
Displays the interface error disabled state.show interface status err-disabled
Cisco Nexus 5000 Series Interfaces Command Reference
26
E Commands
errdisable detect cause