lacp suspend-individual
To enable Link Aggregation Control Protocol (LACP) port suspension on a port channel, use the lacp
suspend-individual command. To disable port suspension on a port channel interface, use the no form of
this command.
lacp suspend-individual
no lacp suspend-individual
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Interface configuration mode
Command History
ModificationRelease
This command was introduced.5.0(2)N1(1)
Usage Guidelines
LACP sets a port to the suspended state if it does not receive an LACP bridge protocol data unit (BPDU) from
the peer ports in a port channel. This can cause some servers to fail to boot up as they require LACP to logically
bring up the port.
This command does not require a license.
Examples
This example shows how to enable LACP port suspension on a port channel:
switch# configure terminal
switch(config)# interface port-channel 100
switch(config-if)# shutdown
switch(config-if)# lacp suspend-individual
switch(config-if)#
This example shows how to disable LACP port suspension on a port channel:
switch# configure terminal
switch(config)# interface port-channel 100
switch(config-if)# shutdown
switch(config-if)# no lacp suspend-individual
switch(config-if)#
Related Commands
DescriptionCommand
Displays LACP information.show lacp
Cisco Nexus 5000 Series Interfaces Command Reference
64
L Commands
lacp suspend-individual
To Next Page
Loading...
