Send feedback to nx5000-docfeedback@cisco.com
1-15
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Using Cisco Fabric Services
Displaying CFS Distribution Information
the network are shown under the local network. In case of a merge failure or a merge in progress, the
local network and the remote network involved in the merge are indicated separately. The application
server in each network that is mainly responsible for the merge is indicated by the term Merge Master.
switch# show cfs merge status name port-security
Logical [VSAN 1] Merge Status: Failed
Local Fabric
----------------------------------------------------------------
Domain Switch WWN IP Address
----------------------------------------------------------------
238 20:00:00:05:30:00:6b:9e 10.76.100.167 [Merge Master]
Remote Fabric
----------------------------------------------------------------
Domain Switch WWN IP Address
----------------------------------------------------------------
236 20:00:00:0e:d7:00:3c:9e 10.76.100.169 [Merge Master]
Logical [VSAN 2] Merge Status: Success
Local Fabric
----------------------------------------------------------------
Domain Switch WWN IP Address
----------------------------------------------------------------
211 20:00:00:05:30:00:6b:9e 10.76.100.167 [Merge Master]
1 20:00:00:0e:d7:00:3c:9e 10.76.100.169
Logical [VSAN 3] Merge Status: Success
Local Fabric
----------------------------------------------------------------
Domain Switch WWN IP Address
----------------------------------------------------------------
221 20:00:00:05:30:00:6b:9e 10.76.100.167 [Merge Master]
103 20:00:00:0e:d7:00:3c:9e 10.76.100.169
The following example of the show cfs merge status name command output displays an application
using the physical scope with a merge failure. The command uses the specified application name to
display the merge status based on the application scope.
switch# show cfs merge status name ntp
Physical Merge Status: Failed
Local Fabric
---------------------------------------------------------
Switch WWN IP Address
---------------------------------------------------------
20:00:00:05:30:00:6b:9e 10.76.100.167 [Merge Master]
Remote Fabric
---------------------------------------------------------
Switch WWN IP Address
---------------------------------------------------------
20:00:00:0e:d7:00:3c:9e 10.76.100.169 [Merge Master]
The show cfs peers command output displays all the switches in the physical network in terms of the
switch WWN and the IP address. The local switch is indicated as Local.
switch# show cfs peers
Physical Fabric
-------------------------------------------------
Switch WWN IP Address
-------------------------------------------------
20:00:00:05:30:00:6b:9e 10.76.100.167 [Local]
To Next Page
Loading...
