Cisco Nexus 5000 Series - Enabling or Disabling Call Home; Testing Call Home Communications

Send feedback to nx5000-docfeedback@cisco.com
1-14
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Smart Call Home
Configuring Call Home
Enabling or Disabling Call Home
Once you have configured the contact information, you can enable the Call Home function.
To enable Call Home in Call Home configuration mode, perform this task:
To disable Call Home in the Call Home configuration mode, perform this task:
Testing Call Home Communications
You can generate a test message to test your Call Home communications.
To generate a test Call Home message, perform this task:
Command Purpose
switch(config-callhome)# no
duplicate-message throttle
Disables duplicate message throttling for Call
Home. Enabled by default.
Command Purpose
switch(config-callhome)# enable
Enables Call Home. Disabled by default.
Command Purpose
switch(config-callhome)# no enable
Disables Call Home. Disabled by default
Command Purpose
switch# callhome send diagnostic
Sends the specified Call Home test message to all
configured destinations.
switch# callhome test
Sends a test message to all configured
destinations.
callhome test and callhome test inventory
commands are supported.
switch# callhome test inventory
[Optional]