Cisco Nexus 5000 Series - Default Physical Ethernet Settings

Send feedback to nx5000-docfeedback@cisco.com
1-11
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Ethernet Interfaces
Displaying Interface Information
Port Debounce time Value(ms)
--------------------------------------------------------------------------------
...
Eth1/1 enable 100
Eth1/2 enable 100
Eth1/3 enable 100
...
The following example shows how to display the CDP neighbors:
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Device ID Local Intrfce Hldtme Capability Platform Port ID
d5-switch-9.qa. Eth1/40 148 R S I WS-C6506-E Ten4/2
dist-row-d mgmt0 147 R S I WS-C3560G-48T Gig0/34
Default Physical Ethernet Settings
The following table lists the default settings for all physical Ethernet interfaces:
Parameter Default Setting
Debounce Enable, 100 milliseconds
Duplex Auto (full-duplex)
Encapsulation ARPA
MTU
1
1. MTU cannot be changed per-physical Ethernet interface. You modify MTU by selecting maps of QoS classes. See Chapter 1,
“Configuring QoS,” for additional information.
1500 bytes
Port Mode Access
Speed Auto (10000)